The wedge is provided with a series of teeth
engaged by a spring-actuated pin or dog, whereby the wedge and the knife
are stopped in proper positions to insure the exact space required
between the two knives.
[Illustration: Fig. 15.]
The back knife, secured to the frame for trimming the base of the slug
as it is carried past by the revolving wheel, should be kept moderately
sharp and adjusted so as to fit closely against the back of the passing
mold. Particular attention should be paid to this feature. The edge of
the knife must bear uniformly across the face of the mold.
[Illustration: Fig. 16.]
The front knives, between which the slug is ejected, should not be made
too sharp. After being sharpened, the thin edge can be advantageously
removed by the use of a thin oilstone applied against the side face;
that is, against the face past which the slug is carried.
The stationary or left-hand knife should be so adjusted as to align
exactly with the inner side of the mold. Under proper conditions this
knife does not trim the side face of the slug, but acts only to remove
any slight fins or projections at the front edge.
Pages:
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64