The
metal, solidifying, forms a slug or linotype bearing on its edge, in
relief, type-characters produced from the matrices. The matrices and the
pot are immediately separated from the mold, and the mold wheel rotates
until the slug contained in the mold is presented in front of an ejector
blade, where the slug is ejected from the mold through a pair of knives,
which trim the sides to the required size, into the receiving galley, as
shown in Fig. 4.
[Illustration: Fig. 3.]
[Illustration: Fig. 4.]
After the line of matrices and spaces has served its purpose, it is
raised from the casting position and moved to the right, as shown by the
dotted lines and arrows in Fig. 2. The teeth in the upper ends of the
matrices are engaged with a toothed bar _R_, known as the second
elevator. This elevator swings upward, as shown by dotted lines,
carrying the matrices to the level of the upper end of the magazine, and
leaving the spaces or justifiers behind to be transferred to their
magazine _H_.
The distributing mechanism consists essentially of a fixed bar _T_,
lying in a horizontal position above the upper end of the magazine, and
having along its lower edge, as shown in Fig.
Pages:
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52